Conductivity vs. Fluorescence for Sugar Leak Detection in Boiler Condensate
Sugar mills have relied on hourly manual condensate sampling for decades, precisely because a sugar leak into boiler condensate is expensive and dangerous to leave undetected. The problem is that manual sampling and conductivity-based online monitoring share the same underlying weakness: neither one is sensitive enough to catch a leak while it’s still small, so […]
What Happens When You Run a Boiler Monitoring System Without a Sample Cooler
Every boiler feedwater and steam condensate analyser on the market — including the Pyxis Guardian IK-2000 series — specifies that it must be installed downstream of a sample cooler. This requirement is stated prominently in the installation documentation, with operating temperature limits of 40–49°C at the sensor inlet. In practice, sample coolers are frequently omitted […]
Why Cation Conductivity Tells You More Than Standard Conductivity in a Boiler System
Standard conductivity measurement is one of the most common parameters in boiler feedwater and steam condensate monitoring. It is fast, inexpensive, and gives a useful general indication of total dissolved solids. But in power generation and co-generation applications, standard conductivity has a significant limitation: it cannot reliably distinguish between contaminants that are genuinely corrosive and […]
Why Real-Time Boiler Water Quality Monitoring Is Not Optional — Conductivity, pH, Dissolved Oxygen, and Hardness Explained
A boiler that runs on poor-quality feedwater does not announce the problem immediately. The damage accumulates quietly — inside heat transfer surfaces, in the steam distribution system, at turbine blades — until it manifests as a tube failure, a forced shutdown, or an efficiency decline that has been building for months. The four parameters that […]